Wago PLC 750-333

Description

Wago PLC 750-333

• Extended Product Type : Module

• Product ID : 750-333

• Wago  Type Designation : Module

Specification

Connection Data

• Connection technology: communication/fieldbus : PROFIBUS: 1 x D-Sub 9 socket
• Connection technology: field supply : 6 x CAGE CLAMP^®
• Connection technology: system supply : 2 x CAGE CLAMP^®
• Connection technology: Device configuration : 1 x 4-pole male connector
• Connection type (1:) : System/field supply
• Solid conductor : Solid conductor
• Fine-stranded conductor : 0.08 … 2.5 mm² / 28 … 14 AWG
• Strip length : 8 … 9 mm / 0.31 … 0.35 Inch

Technical Data 

• Communication : PROFIBUS
• Max. no. of I/O points : 6000
• Baud rate : 9.6kBd … 12MBd
• Fieldbus segment length max. : 1200 m
• System supply voltage : DC 24 V (−25 … +30 %); via wiring level (CAGE CLAMP^®connection)
• Current consumption, system supply (5 V) : 200 mA

Geometrical Data 

• Width : 50.5 mm / 1.988 inch
• Height : 71.1 mm / 2.799 inch
• Height from upper-edge of DIN-35 rail : 63.9 mm / 2.516 inch
• Depth : 100 mm / 3.937 inch

Mechanical Data

• Type of mounting : DIN-35 rail

Material Data

• Color : light gray
• Housing material : Polycarbonate, polyamide 6.6
• Weight : 183.143 g
• Conformity marking : CE

Environmental requirements 

• Surrounding air (operating) temperature : 0 … 55 °C
• Surrounding air (storage) temperature : -40 … 85 °C
• Relative air humidity (no condensation) : 95 %
• Exposure to pollutants : Per IEC 60068-2-42 and IEC 60068-2-43

Description

• This buscoupler interfaces the I/O modules of the WAGO‐I/O‐SYSTEM to PROFIBUS DP.
• When initializing, the buscoupler determines the module structure of the node, to create the process image in PROFIBUS. In order to optimize addresses, the I/O modules with a bit width smaller than 8 are grouped in one byte.
• It is furthermore possible to deactive I/O modules and to modify the image of the node according to the connected signals without having to modify the existing application.
• The diagnosis concept is based on diagnostics according to the EN 50170 standard. Therefore the programming of modules is not necessary to interpret the diagnostic information from each manufacturer.